PZ30 Lighting distribution box

Product Overview
The PZ30 lighting distribution box is suitable for single-phase and three-phase circuits with a frequency of 50Hz, a rated voltage of 500V and below, and a load current not exceeding 100A. It is used for power and lighting, motor control, and overload, leakage, and short circuit protection of the circuit. This box has a reasonable design, small volume, beautiful appearance, safe and reliable use, and can be widely used in factories, buildings, residential areas, shopping malls and other places
This product complies with GB7251.3 "Low voltage switchgear and control equipment, Part 3: Special requirements for distribution boards for low voltage switchgear and control equipment that non professionals can enter the site"

Usage conditions
Altitude: not exceeding 2000m
Environmental temperature: The ambient air temperature should not exceed 40 ℃ and should not be lower than -25 ℃
Relative humidity: The monthly average relative humidity of the air at+20 ℃ should not exceed 90%
Places without severe vibration and impact
There is no explosive hazardous area, and there is no gas or conductive dust in the medium that can corrode metals and damage insulation
Note: If ordering this product exceeds the above conditions, please consult with our company
GR Product Structure
The PZ30 lighting distribution box is made of high-quality steel plate with a thickness of 1.0mm. The shell is treated with high-voltage electrostatic spraying. Paired with a plastic transparent cover, it has a beautiful and elegant appearance, with knock off holes punched on both the upper and lower sides of the shell, making it convenient for users to enter and exit the line
Factory standard combination system with horizontal block structure
Each box design is innovative and aesthetically pleasing, combining standardization and serialization
Lighting box single-phase and three-phase can be used interchangeably; Monopole, multipole, and leakage can be combined arbitrarily
Rated current ≤ 100A, enclosure protection level reaches IP3X
Ultra thin structure suitable for concealed installation and wall hanging installation of lightweight structural walls
Safe and reliable single-phase and three-phase comb shaped busbar connections, as well as busbar insulation protection sleeves, provide higher safety performance and better thermal stability



Ordering Notice
When placing an order, users must specify the number of circuits in the distribution box, the circuit current, and the number of poles of the circuit breaker
If equipped with a main switch, the current and number of poles of the main switch should be indicated
Indicate the direction, quantity, and size of the import and export lines
If lighting, power, and leakage are mixed, a schematic diagram must be provided